Specifications

Initial Configuration 31
© 2011 Datacom Systems Inc
4.1.4.22 SET SNMPv3 SUPERUSER (SE V3 SU)
SET SNMPV3 SUPERUSER (SE V3 SU) name auth authPass priv privPass: This command is
required to create an SNMP V3 user. There MUST be at least one SNMP user for the feature to
work. It is entered as shown:
SET SNMPV3 SUPERUSER (SE V3 SU) name auth authPass priv privPass
where:
name SNMP principal [maximum of 32 characters]
auth MD5/SHA [authorization encryption type]
authPass authorization password - at least 12 characters
priv DES/AES [privilege encryption type]
privPass privilege password - at least 12 characters
Example:
> SE V3 SU username MD5 12characters DES characters12
SNMP V3 user created
4.2 SERIAL Port Configuration (DB9)
Note: Use of the SERIAL DB9 port, which is fairly simple and straight forward, is strongly
recommended for initial configuration of the hardware.
4.2.1 HyperTerminal
Once series connection is made, any freely available terminal emulator may be utilized, however
Microsoft HyperTerminal is the preferred terminal emulation program, but please take note of the
specific HyperTerminal setup settings if an alternate terminal emulator is used.
HyperTerminal (terminal emulator) enter:
9600 bits per second
8 data bits
Parity none
1 stop bit
Flow control none
After completing review of the Command Line Interface (CLI) section and Exercise - CLI setting
Ports section, detailed IP Address configuration can be found in the IP Address Configuration
section.
19
41 33