Specifications

VS-1200-S Data Acccess Switch28

# SE PO MO 3 OFF

NOTE: See the 'Exercise - CLI Setting Ports ' and 'Application ' sections for further

explanation and examples using input and output settings for tap and Any-to-Any ports.

4.1.4.12 SET PORT NAME (SE PO NA)

This command, followed by the port number or port name, a command separator (TO), then the

name text (up to 32 characters), assigns the new name text entered as shown:

SET PORT NAME (SE PO NA) port number or port name TO name text

Example:

# SE PO NA 4 TO Port 4

4.1.4.13 SET PORT SPEED (SE PO SP)

Speed duplex is one of the following: 10HALF, 10FULL, 100HALF, 100FULL, 1000FULL,

AUTO. This command changes the port speed for a single port or a group of ports as shown:

SET PORT SPEED (Comma separated list of Port numbers, port names, or group names) (Speed

duplex)

Example:

# SE PO SP 4,6,7,8 100HALF

Speed set for port(s) 4, 6, 7, 8

4.1.4.14 SET PORT VTAG (SE PO VT)

This command is used to change the capability of a port to either pass VLAN Tags or strip them

from a frame and recalculate the CRC of the frame as shown:

SE PO VT (Comma separated list of port numbers, port names, or group names) ON/OFF

Example:

# SE PO VT 1,4,6,7 ON

4.1.4.15 SET TCP PORT (SE TC PO)

This command configures the TCP Port (default 2370) parameter. Initially this should be done using

the serial port with a terminal application. The parameter is entered as shown:

SET TCP PORT (SE TC PO) [nnnnn]

Example:

# SE TC PO 17216

TCP Port is now updated.

41 55