Specifications

Initial Configuration 21
© 2011 Datacom Systems Inc
SET SNMPv3 SUPERUSER SE V3 SU Set SNMP SuperUser Parameters
SET SSH SE SH Set SSH ON or OFF
SET SSH KEY SE SH KY Set SSH Key
SET SUBNET SE SU Set Subnet Mask nnn.nnn.nnn.nnn
SET TCP PORT SE TC PO Set TCP Port
SET TELNET SE TE Set Telnet ON or OFF
SET TIME SE TI Set System Time
SET UPGRADE SE UP Set Upgrade ON or OFF
SHOW SH Show All Current Configurable Values
SHOW GROUPS SH GR Show Group Configuration
SHOW MANAGEMENT SH MA Show Management Configuration
SHOW PORT CONFIG SH PO CO Show Port Configuration
SHOW PORT ROUTING SH PO RO Display Routing Summary
SHOW PRODUCT SH PR Show Product Name and Serial Number
SHOW TIME SH TI Show System Date and Time
SHOW USERS SH US Display Users
SU SU Enter Superuser Mode
SU SET PASSWORD SU SE PA Set Superuser Password
4.1.3.2 POWER STATUS (PO ST)
This command displays power supply status. It is entered and displays data as shown:
> POWER STATUS (PO ST)
Example:
> PO ST
Power Supply 1: Good
Power Supply 2: Good
>
4.1.3.3 SHOW (SH)
Using this command alone, displays general information about the product as shown:
Example:
> SH
Date/Time: 02-24-2011 16:38:31
Product: VS-1210BT/SFP-S
Serial Number: 9326023
Version: 5.3.1.4
Security Version 1.0.0.14
MAC Address: 00-14-e2-00-10-d3
IP Address: 192.168.1.1
IP Subnet: 255.255.0.0
IP Default Gateway: 192.168.1.0
IP Port: 2370
FlashUtils protocol: enabled
Telnet protocol: enabled