User guide

SS-1200-S, SS-2200-S and SS-4200-S Series Link Aggregating Taps62

TAP (SS-1200BT-S series port 1 and port 2) or TAP 1 and TAP 2 (SS-2200-S series port 1 and

port 2; port 3 and port 4) are RJ45 connectors used for connection to network segments. These

jacks have integrated LEDs that display line status and line speed of each port. See the TAP LED

Display Code table for LED display codes.

5.1.2 Fiber Optic SS-1200LX-S and SS-1200SX-S series

This section shows the fiber optic SS-1200LX-S or SS-2200SX TAP connection(s) of the typical

configurable series hardware installation.

Step 1. Connect one of the fiber optic duplex network cables to a TAP port socket. The LINK LED

associated with this TAP quad-LC socket illuminates green indicating light signal has been detected

on the respective Rx TAP port.

Step 2. Connect the other fiber optic duplex network cables to the other TAP port socket. The

LINK LED associated with this TAP quad-LC socket illuminates green indicating light signal has been

detected on the respective Rx TAP port.

TAP (SS-1200LX-S and SS-1200SX-S series port 9 and port 10) are dual-duplex LC connectors

used for connection to network segments. The LEDs located to the right of the dual-duplex LC

connectors are solid green indicating a light level link has been detected by the respective TAP Rx

port.