User guide

Initial Configuration 45

Step 10. SET GATEWAY (SE GA) (if needed) by typing se ga xxx.xxx.xxx.xxx corresponding

to your network's default gateway. Press the Enter key to continue.

Step 11. SHOW (SH) by typing sh and press the Enter key to display and affirm that the pending

IP Address, IP Subnet and IP Default Gateway match the intended Local Area Network input IP

Address, IP Subnet and IP Default Gateway.

Step 12. If the pending IP Address is not correct, repeat Step 8, if the pending IP Subnet is not

correct, repeat Step 9 and if the pending IP Default Gateway is not correct, repeat Step 10.

Repeat Step 11 to review and verify that the pending IP Address, IP Subnet and IP Default

Gateway match the intended Local Area Network input IP Address, IP Subnet and IP Default

Gateway.