User guide

SS-1200-S, SS-2200-S and SS-4200-S Series Link Aggregating Taps44

Step 6. Next, configure the COM Properties. The initial correct settings to communicate with the

SS-1200-S, SS-2200-S or SS-4200-S series (9600, 8, None, 1, None) are shown below. Once

all settings are configured correctly, click Apply, then click OK.

Step 7. You are now connected to your SS-1200-S, SS-2200 or SS-4200-S series. Hit the Enter

key twice in succession (i.e., Enter, Enter) to display the Enter Username: prompt. All Usernames

and passwords are case-sensitive. Type Administrator (default value) and press the Enter key. At

the Enter Password: prompt, type admin (default value) and press the Enter key to display the

command line > prompt. At the command line > prompt, type su and press the Enter key. At the

Enter Password: prompt, type password (default value) and press the Enter key to display the

command line # prompt. To see a list of available commands, at either the > or # command line

prompt, type ? and press the Enter key.

Step 8. SET IP (SE IP) by typing se ip xxx.xxx.xxx.xxx corresponding to a valid IP address for

your network. Press the Enter key to continue.

Step 9. SET SUBNET (SE SU) by typing se su xxx.xxx.xxx.xxx corresponding to your

network's subnet mask. Press the Enter key to continue.