User guide

Initial Configuration 35

Example 2:

# SE PO MO 4 FROM 3,2,PortNine

Example 3:

# SE PO MO 3 OFF

NOTE: See the 'Exercise - CLI Setting Ports ' and 'Application ' sections for further

explanation and examples using input and output settings for tap and Any-to-Any ports.

4.1.4.14 SET PORT NAME (SE PO NA)

This command, followed by the port number or port name, a command separator (TO), then the

name text (up to 32 characters), assigns the new name text entered.

NOTE: PORT NAME is shown within the SHOW PORT CONFIG (SH PO CO) display.

It is entered as shown:

SET PORT NAME (SE PO NA) port number or port name TO name text

Example:

# SE PO NA 4 TO Port 4

4.1.4.15 SET PORT SPEED (SE PO SP)

This command changes the port speed for a single port or a group of ports.

NOTE: PORT SPEED is shown within the SHOW PORT CONFIG (SH PO CO) display.

It is entered as shown:

SET PORT SPEED (Comma separated list of Port numbers, port names, or group names) Speed

duplex is one of the following: 10HALF, 10FULL, 100HALF, 100FULL, 1000FULL, AUTO.

Example:

# SE PO SP 10 1000FULL

4.1.4.16 SET PORT VTAG (SE PO VT)

This command is used to change the capability of a port to either pass VLAN Tags or strip them

from a frame and recalculate the CRC of the frame as shown:

SE PO VT (Comma separated list of port numbers, port names, or group names) ON/OFF

Example: # SE PO VT 1,4,6,7 ON

50 69