User guide
SS-1200-S, SS-2200-S and SS-4200-S Series Link Aggregating Taps20
© 2012 Datacom Systems Inc
LX-BT/SX-BT - TAP (SS-1204LX-BT-S and SX-BT-S port 3 and port 4) are dual-duplex LC
connectors for connection to network segments. The LEDs to the right of the dual-duplex LC
connectors are solid green when a light level link has been detected by the respective TAP Rx port.
LX-SFP/SX-SFP - TAP (SS-1204LX-SFP-S and port 1 and port 2) or TAP 1 (SS-2206SX-SFP-
S port 1 and port 2) and TAP 2 (SS2206-SX-SFP-S port 5 and port 6) are dual-duplex LC
connectors for connection to network segments. The left LEDs below the dual-duplex LC
connectors are solid green when a light level link has been detected by the respective TAP Rx port.
The right LEDs solid green indicates 1,000 Mbs link speed.
3.4.3 Any-to-Any Ports
Superuser assigned INPUT or OUTPUT ports. See Serial and Management Port - Command Line
Interface - Superuser Commands - 'SET PORT MONITOR (SE
Ports: 1 to 2 (SS-1204LX-BT-S or SS-1204SX-BT-S ):
Ports: 3 to 4 (SS-1204BT-BT-S):
Ports: 5 to 6 (SS-2206BT-BT-S):
Ports: 5 to 8 (SS-2210BT-BT-S):
are RJ45 connectors used for connection to network devices or tools. These jacks have integrated
LEDs that display line status and line speed of each port. See the Any-to-Any RJ-45 LED Display
Code table for LED display codes.
Ports: 3 to 4 (SS-1204BT-SFP-S, SS-1204LX-SFP-S and SX-SFP-S, SS-2206SX-SFP-S):
Ports: 9 to 10 (SS-2210BT-SFP-S):
Ports: 9 to 10 (SS-4210BT-SFP):
are sockets used with a small form-factor plug (SFP) module for connection to network devices or
tools. They can be connected through fiber or copper, or a mix of each.
34