User's Manual

Welcome Screen

The first time you run the SpyderX Elite software, you will be greeted with a

Welcome Screen:

There are 4 Checkboxes on this screen:

1) Warm Up

Please make sure that your display has been powered up for at least 30

minutes prior to doing a calibration.

2) Lighting Conditions

Please make sure that there is no direct light falling on your display as

this could have an adverse effect on your calibration.

3) Display Controls

If your computer has these controls, make sure to set them to the default

settings or equivalent.

4) Spyder Connection

Please plug your SpyderX Elite into a USB port on your computer.

Please avoid using a hub, extension cable, or a port on a keyboard as

this could prevent the Spyder unit from getting the proper data flow.

These checkboxes will only be activated the first time you run the software, the

next time you run the software the reminders will show up, but you will not need

to check the boxes again.

Once you have completed this step, please click the “Next” button in the lower

right corner.