User Manual

49
If you have selected Room Light On or Automatic, the calibration process will
stop about a minute into the process and ask you to adjust your display
brightness to the recommended level. Once you have made an adjustment,
either up or down, hit the “Update” button, it will check the brightness level again
to see if you are close to the recommended setting.
When you are within the parameters, you can press the “Continue” button. It may
take a couple of times to get your brightness set properly, please try to get as
close as possible to the target, though it may not fall completely within the range,
that is ok, as long as you are as close as you can be.
Once the measuring is completed, click on the “Finish” button to proceed.