User Manual

Calibration Settings

If this is your first time calibrating this display, you will automatically have Full

Calibration selected here. On subsequent calibrations you can choose doing a

FullCAL, a ReCAL, or a CheckCAL. A FullCAL will perform a full calibration of

your display. A ReCAL will recalibrate your display and a CheckCAL will check to

see if your display is still accurate.

You will also see your current target settings for Gamma, White Point, and

Brightness here. To make an adjustment to either of these targets, please

choose the drop down next to each setting to make your changes.

Here you will also choose whether you would want the Spyder to read your room

light in order to help set the brightness of your display properly based on the level

of lighting in your room. If you want to read your room light, you have the option

to either receive a notification when a change is detected, and a new calibration

is suggested, or use automatic room light switching. Automatic switching creates

multiple profiles that the software will change between, without any action

needed on your part, as the plugged in SpyderX sensor detects a shift in room

light level.

**Please remember: you must have the SpyderX sensor attached via USB to

your computer in order for it to take measurements and notify you when a

change has been detected or to adjust your screen automatically.

Once you have made your selections click “Next” to move onto the next screen.