User's Manual

DSD Gen5

User Manual

Edition 9.1 _ 1911

DSD Gen5_Smartphone_User manual_Edition 9.1_1911_GB

DataCollect reserves the right to change any information contained within this technical note at its own discretion

If you want to give the DSD alias name, please click on the serial number and an editable field

will open. Here you can assign an alias name at any time. For example you can number your

DSD. Confirm the entry with Enter. In addition to the serial number, the name you assigned is

now displayed in the device list.

First of all you can perform the basic configuration of your DSD in the basic settings panel.

*In all cases, an increase of the respective value leads to a brighter display. Respectively, a reduction of the values

leads to a lesser brightness of the light-emitting diodes.

Caution: We recommend to not change the factory-set values!

11.1.1 Settings in the panel Apps

Under the panel Apps you can select the basic functions of your DSD. Only the apps you have

purchased can be activated. An explanation of the individual apps can be found in Chapter 9

Apps of the DSD.

The apps which you need for your current measurement can be activated by ticking the box.

Attention: only purchased apps can be activated.

Basic setting

Description

Speed measurement

Switchover option between km/h and mp/h

V(min)

Speed from which recorded vehicles are stored and displayed.

V-correction

If the measuring location does not allow perfect installation and you detect a deviation of

the measured speed, you can manually correct that speed. The set value is then added

or subtracted upon each recorded speed. Standard value = 0.

Flashing frequency

Here you can set the duration of the display of individual elements when changing over

between speed and safety. Default value = 8 / minute.

Brightness, daytime *

Defines the brightness depending on the daylight recorded by the DSD.

Default value = 128

Brightness, nighttime *

States the basic brightness of the DSD display. Default value = 10