User's Manual

DSD Gen5

User Manual

Edition 9.1 _ 1911

DSD Gen5_Smartphone_User manual_Edition 9.1_1911_GB

DataCollect reserves the right to change any information contained within this technical note at its own discretion

10 Activation of the DSD

If www.mytrafficdata.com is used, Datacollect will activate the DSD on your account.

Use as a speed display

If the DSD is used solely as a speed display, without safety display, no further settings need to

be made!

Setup via Handie App (optional)

The handie function is used to change the safety threshold without using a DataCollector. You

may choose between the following threshold values:

7 km/h, 10 km/h, 20 km/h, 30 km/h, 40 km/h, 50 km/h, 60 km/h, 70 km/h, 80 km/h, 90 km/h and 100 km/h.

00 = Off

The Handie function can only be adjusted during the start sequence of the display system.

Therefore, the power supply of the DSD must be briefly interrupted (by removing and re-installing

the power supply).

The start sequence now starts again, while the safety threshold can

be adjusted. During the start sequence, a horizontal bar (see

illustration) appears. As soon as this is visible, the adjustment of the

threshold value can be performed.

Cover (while the horizontal bar is visible) the area marked by the hand

three times extensively, i.e. cover the light sensor, remove the cover,

cover, remove etc. Then the last set safety threshold is displayed. If

you then again cover the light sensor and remove it again, the next

available threshold value is displayed.

Repeat these steps until your desired threshold value is reached. If you do not make any changes

for approx. 10 seconds, the selected safety threshold is confirmed by flashing three times. The

start sequence is now continued and ends with the display of the battery voltage. The DSD is

ready for operation with the desired threshold value.