User`s guide

ImageCard/UltraGrafix (Express and Select Classes) User’s Guide
B-3
Card requirements
Card stock for printing should meet the following requirements.
Size
: CR80, 3.375 in. (85.725 mm) x 2.125 in. (53.975 mm)
Type
: PVC with glossy surface or composite with glossy PVC surface
Thickness
:
•
0.020 in. (0.508 mm) to 0.050 in. (1.27 mm) plus or minus 10 percent,
for regular or magnetic stripe cards when the smart card module is
not installed
•
0.020 in. (0.508 mm) to 0.030 in. (0.762 mm) plus or minus 10 percent,
for all cards when a smart card module is installed
Card bow must be less than the thickness of the card (see Figure B:-1).
74030c10
Card bow must be less
than the thickness of
the card.
Figure B:-1 Card bow requirement
Printhead cartridge
There are three types of printhead cartridges. You can tell which type is in
your printer by looking for a sticker on the cartridge, as shown below:
ice0006
Printhead -- do not
touch this surface
A sticker on this surface
indicates the type of
printhead cartridge (see
table below).
Figure B:-2 Printhead cartridge