User guide

Custom Desktop Issuance 6.0 - User Guide
Name: CDI_0.docx September 2012
Page 17 / 78
Ultragrafix Setup (for Ultragrafix machines)
Make sure Operate on Card is checked if graphics printing is desired on a production
card.
Embossing Setup (for Embossers)
Make sure Operate on Card is checked if Embossing is desired on a production card.
Topper Setup (depending on the type of the machine)
Make sure Operate on Card is checked if Topping is desired on a production card.
Select a number from 1 to 5 for heat control of the topper platen. Foils require different heat
level settings.
Magnetic Stripe Setup
Make sure Operate on Card is checked if a Magnetic Stripe encoding is desired on a
production card. On 150i printers only, make sure to select the coercivity (Hico or Loco).
SmartCard Setup (if a coupler is used)
Make sure Operate on Card is checked if a Smart Card option is used on a
production card.
Depending on the type of the machine, make sure Front Chip is checked if the Smart
Card is on the front side of the production card or Back Chip is checked if on the backside of
the production card.
SmartCard Module (if a coupler is used)
Selected smart card applications are displayed in this box (not used with Use APM
option).
Control Codes (28X printers only)
Refer to the 28X Operator’s manual for explanation of the control codes or leave
blank as a default.
Options Table (28X printers only)
Allows the selection of the 28X printer option control table. Up to 9 different
configuration options can be selected. Refer the 28X Operators’ manual for details.
Input Hopper (DC315GX-FR only)
Allows to select the DC315GX-FR input hoppers to be used during the
production. Max configuration: 15 input hoppers. Hoppers selected by user
will be activated during the production. If one selected hopper is empty (no
card inside) machine will automatically switch on the next selected hopper.