User`s guide

SD Series Card Printer User’s Guide A-9
5.
Loadthenewrolloflaminator
overlaymaterial.
A. Putthebluesupplyspoolonthe
bluesupplyspindle ofthe
cartridge(c).Theoverlaysupply
rollcangoononlyonewa yand
onlyfitsonthecorrectspindle.
B. Puttheemptysilvertake‐up
spoolonthesilvertake‐up
spindle(d).
C. Turnthetake‐upspoolclockwise
toremoveslackfromthe
material(e).Theoverlay
materialloadsinanS‐shape.
Makesurethattheoverlay
materialisbetweentheguideson
boththetake‐upandsupplysides
ofthecartridge.
6. Closethelaminatorcartridgegate(f).
Pushitinuntilthelatchclicksin
place (g).Makesurethattheoverlay
materialisnotpinchedbythe
cartridgegate.
7. Replacetheloadedlaminator
cartridgeintheprinter.
8. RemovetheL2(orange)cartridge,ifinstalled,fromthelaminator.
9. Repeatsteps3through7toloadtheoverlayontothecartridge.
10. Closethelaminatoraccessdoor.