User`s guide

36 System Maintenance
Prepare the Printer for Use
1. Unlocktheprinterandopenthemulti‐hopperdoor.
2. Removetheusedcleaningcardsfromthehoppers.
3. Replacetheunprintedcardsintheinputhoppers.
4. Opentheprintersuppliesaccessdoorand
theprintercover.Removetheprintribbon
cartridge.
5. Installanewcleaningsleeveontheribbon
cartridgeandremovetheprotectivecover.
Referto“LoadtheCleaningSleeve ”on
pag e 20forthestepstofollow.
6. Replacetheribboncartridgeandclosethe
printercoverandtheprintersupplies
accessdoor.
7. Opentherejectcardtrayandremovetheusedcleaningcard.
8. Locktheprinter.
TheprinterreturnstoReadyandisavailabletoprintcardsagain.

9. Discardtheusedcleaningcardsandcleaningsleeve.
HINTS&TIPS
• Usethecleaningcardsandcleaningsleeveonetimeonly.
• Changethecleaningsleeveeachtimeyoucleantheprinterorchangethe
printribbon.