User`s guide

32 System Maintenance
F. Insert cleaning carddisplaysontheLCDpanel.PresstheUSERbuttonto
startthecleaningcycle.
Theprintermovesthecardthroughtheprinterseveraltimesandejectsit
intheoutputhopper.
3. Removetheusedcleaningcard.Waitafewminutesfortherollerstodry.
4. Preparetheprinterforuse.
A. Replacethecardsintheinputhopper.
B. Installanewcleaningsleeveontheribboncartridgeandremovethe
protectivecover.Referto“LoadtheCleaningSleeve”onpag e 20forthe
stepstofollow.
C. Replacetheribboncartridgeandclosetheprintercover.
PresstheUserbuttontoreturntheprintertoReady.Theprinteris
availabletoprintcardsagain.
D. Discardtheusedcleaning cardandcleaningsleeve.
HINTS&TIPS
• Usethecleaningcardandcleaningsleeveonetimeonly.
• Changethecleaningsleeveeachtimeyoucleantheprinterorchangethe
printribbon.
Ifthecardlightisblinkingamberandtherearecardsintheinputhopper,it
indicatesthattheprinter’sconfiguredcleaningcounthasbeenreachedandit
istimetocleantheprinter.