User`s guide

18 Using the System
Load and Replace Supplies
Topreparetheprintertoprintcards,loadblankcardstockintotheinputhopper
(optional),andloadprintribbonandacleaningsleeveont otheprintcartridge.
Load Cards
Single Hopper
Ifyouareusingamanualfeedprinter,skipthisstepandkeepasupplyofblank
cardsclosetotheprinter.
Forprinterswithaninputhopper,do
thefollowing:
1. Opentheinputhopper.Unlock
theprinter,ifnecessary.
2. Loadthecardsintotheinput
hopper.(Fanthecardsbefore
placingthemintheinput
hopper—optional.)
• Insertmagneticstripecards
withthestripedownand
towardtherightsideoftheinputhopper.
• Insertsmartcardswiththesmartcardchipontoptowardthebackofthe
hopper.
3. Closetheinputhopper.Locktheprinter,ifnecessary.