User`s guide

Maintaining the printer 4-9
User’s Guide for Magna™ Platinum Series™ Printers
e Lightly wipe any dirt from the end of the cleaning pen onto a clean cloth or
paper. Move the cleaning pen to another area of the roller.
f Repeat steps c through e for the roller at location 4 until no more dirt appears
on the pen or cloth.
You can also clean the rollers in the duplex or pass-through mechanism
(location D in Figure 4-8), and in the laminator (location L in Figure 4-8). Turn
the black duplex wheel to move rollers in the duplex or pass-through
mechanism. Turn the laminator advance knob to turn the wheels in the
laminator.
5 Close the printer cover.
If the printer has a locking top cover, lock the cover after closing it.
6 Replace the card cartridge.
If the printer has a locking card cartridge, lock the cartridge after replacing it.
7 Print a card to verify the quality of printing. You can print a printer test card, a
sample card, or a card using your card creation application.
♦
Using the duplex/laminator cleaning card
If your printer includes a duplex module, a topcoat module, or an overlay module, use
the duplex/laminator cleaning card to maintain card quality and reduce the likelihood
of jammed cards in the duplex and laminator modules.
Use the duplex/laminator cleaning card once a month or when problems occur, such
as repeated card jams in the overlay or topcoat module. See “Supplies and cards” on
page B-1 for ordering information.
Use the duplex/laminator cleaning card
If the printer has a locking card cartridge, unlock the cartridge before removing it.
1 Remove the card cartridge and set it aside.
If the print ribbon sticks to the duplex/laminator cleaning card, remove the
print ribbon and repeat this procedure with a new cleaning card.
2 Peel the middle strip of protective paper from both sides of the duplex/laminator
cleaning card (see Figure 4-9).
The outside protective paper strips must stay on the card.
i
i
E
i
i
i