User`s guide

SR200 & SR300 Card Printers and LM200 & LM300 Laminators User’s Guide 47
Laminator Tab
TheLaminatortabisenabledifalaminatorisconnectedtotheprinter.Usethesettingstoadjust
laminationforbestresults.Referto“SuggestedLaminatorSettings”onpage 69forexamplesof
settingsforsingle‐sidedanddouble‐sidedlamination.
TheLaminatortabdisplays:
 BasicSettings:
 LaminateMode:
 SelectLaminatetolaminateacard.
 SelectPassThroughtoskiplamination.
 HRControl:
 Read‐only.DisplaysEnableifHRControlis
enabledonthePrinterSettingtab.When
enabled,thetemperatureofthelaminatorheat
rollerisloweredwhentheprinterandlaminator
arenotusedfor30minutesorlonger.
 Thissettingworkswiththecardprintersetting(referto“PrinterSettingTab”on
page 42).ThisisalwayssettoOnautomaticallywhenoverlayfilmisselected.(Put
thelaminatorintostandbymodeifyouwillnotbeprintingcardsforalongtime.)
 CleaningCounter:Displayshowmanylaminationshavebeenperformedsincethelast
rollercleaning.
 Bott omandTopSideSettings:
 CassetteStatusfield:DisplaysCassetteisDetectedorNoCassette.
 FilmType:PatchorOverlay.Referto“LaminatorMaterial”onpage 106formore
information.
 Patchposition:Referto“AdjustingthePatchPosition”onpage 93formoreinformation.
 Heatrollertemperaturesetting:Setsthetemperatureforthelaminatorheatroller.
 CommonSettings:
 Speed:Setsthecardspeedduringlamination.
 CoolingTime:Setsthestandbytimeforcoolingdownthecardbeforelaminationstarts.