User`s guide

SR200 & SR300 Card Printers and LM200 & LM300 Laminators User’s Guide 19
Powering On
Usetheseprocedurestochecktheconnectionsandthenpowerontheprinterandlaminator.
Checking the PC Connection
TheprinterandPCareconnectedwhentheprinterisinstalled.Followinstructionsinthe
DatacardSR200&SR300CardPrintersandLM200&LM300LaminatorsInstallationGuideto
connectandsetuptheprinter.ToavoidreceivingerrormessagesontheLCDpanel,makesure
thatallsuppliesareproperly
loadedandinpositionbefor epoweringontheprinter.
Beforeyoubeginprocessingcards,makesurethat:
 Theprinterdoorandcardhopperareclosedsecurely.
 Thepowercordissecurelyconnectedtotheprinterandanappropriategroundedpower
source.
 Thecardstackerisattachedtotheprinterortothelaminator,ifused.
 Thecardsandallothersuppliesareloaded.Referto“LoadingSupplies”onpage 12for
instructions.
 TheUSBdata cableissecurelyconnectedtotheprinterandthePC,aftertheprinterdriver
hasbeeninstalled.
OR
 Thenetworkdatacableissecurelyconnectedtotheprinterandtoanetworkport.