User`s guide

16 Using the Printer and Laminator

Loading Retransfer Film

1. Slidethedoorlatchupandopentheprinterdoor(1).

2. Presstheretransferfilmreleasebuttonandremovethe

greencartridge(2).

3. Removebothusedfilmspoolsfromthecartridge(if

present).

4. Loadthenewrollofretransferfilmonthecartridge:

a. Putthefullrolloffilmon

thegreensupplyspindle

(A).

b. Puttheemptytake‐upspoolontheblacktake‐up

spindle(B).

c. Alignfilmalongthethreefilmguides.

d. Windtwoframesoffilmontothetak e‐upspool

(D).Setthefilmsothatablackframelineis

positionednexttothefilm

guide,asshownonthelabelinsidethecartridge.

e. Takeupanyslackbyturningthetake‐upknob

clockwise.Gentlypullthetake‐upknobandturn.

Ifslackcannotberemoved,verifythatthesupply

andtake‐upspoolsarefirmlyseatedonthe

spindles.

Toeaseinsertinginto

theprinter,thefilmmust

betightalongthefilmguides.Turningthesupply

andtake‐upknobshelpsmaintaintheproper

tension.

5. Replacetheloadedfilmcartridgeintheprinteruntilit

clicksintoposition(5).

6. Closetheprinterdoor(6).

Theretransferfilmcartridgecannotbeloadedifthe

printerisintransportmode.Powerontheprinter

untilitdisplaysanerror,andthenpoweritoffagain

tocanceltransportmode,ifnecessary.