User`s guide

SR200 & SR300 Card Printers and LM200 & LM300 Laminators User’s Guide 99
Laminator LCD Messages
ThistabledescribesthelaminatormessagesthatmaybedisplayedontheprinterLCDpanel:
MGMechanical Thereisamagneticstripe
mechanicalerror.
Powertheprinteroffandthenonagain.Callfor
serviceiftheproblempersists.
MGHardware Thereisamagneticstripe
hardwareerror.
Powertheprinteroffandthenonagain.Callfor
serviceiftheproblempersists.
MGTestErr Awriteerroroccurred
duringself‐te st.
1. Verifythatthetypeandorientationof
magneticcardsinthecardhopperiscorrect,
asdescribedin“LoadingCards”onpage 12.
2. Pre ssResetandthentoinitializethe
printer.
LCDMessage PossibleCause Solution
Jam(In) Thereisacardjaminthe
entrancearea.
Makesurethatthelaminatorisproperly
connectedtotheprinterasdescribedin
“CheckingtheLaminatorConnection”on
page 20.
Referto“ClearingaCardJam”onpage 91to
clearthejam.
Jam(Middle) Thereisacardjamnear
theheatingroller.
Thelaminatingtemperatureistoohighorthe
speedis
tooslow.Setthetemperatureorspeed
asdescribedin“LaminatorTab”onpage 4 7.
Referto“ClearingaCardJam”onpage 91
to
clearthejam.
Jam(Out) Thereisacardjaminthe
carddischargearea.
Thelaminatingtemperatureistoohighorthe
speedistooslow.Setthetemperatureorspeed
asdescribedin“LaminatorTab”onpage 4 7.
Referto“ClearingaCardJam”onpage 91to
clearthejam.
Film‐BRunOut Theendoftherollmark
hasbeendetecte d.
Replacethelaminatingmaterialas
describedin
“LoadingTop‐SideLaminateFi lm”onpage 17.
PrinterLCDMessage PossibleCause Solution