Installation guide

Table Of Contents

SR200 & SR300 Card Printers and LM200 & LM200 Laminators Installation Guide 13

Card Stacker on Optional Laminator

WhenanLM200orLM300laminatorisinstalled,hangthecardstackeronthelaminator’scard

stackerreceptacle.Besuretohangthecardstackerontheattachmentslots,notonthecardout

slot.

Plugging in the Power Cord(s)

Usethisproceduretoconnecttheprovidedpowercordtotheprinter,andtothelaminator(if

used).

1. Verifytheplugtype.Thepowercordsvaryaccordingtomodelandcountryofpurchase.

2. Plugthepowercordintothepowerreceptacleatthebackoftheprinter.

Warning:Alwaysuseagroundedpoweroutletthatisnotsharedwithotherelectrical

equipment.

Caution:UseanAutomaticVoltageRegulator(AVR)ifthereisapossibilityofvoltage

fluctuations.UseanuninterruptiblepowersourceratherthananAVRifthereisa

possibilityoffrequentpowerloss.

CardOutSlot