User`s guide

Using the printer 5-13

User’s Guide for the ImageCard® IV Printer

You can remove the card from the print station or allow the printer to clear the

card.

5 Replace the print ribbon cartridge. See “Replacing the print ribbon cartridge” on

page 4-4.

6 Close the cover of the printer and press to latch it. If the printer has a lock, lock the

printer.

7 Select the Retry, Cancel, or Okay button on the message box displayed on the

PC.

The card moves to the reject bin.

8 Return to the card creation program to send the card to print again.

♦

Removing cards

Remove completed cards from the output tray when an "Output tray full" message

appears or to distribute printed cards. The output tray holds up to 250 cards with a

nominal thickness of 0.030 inch (0.76 mm).

You can remove cards when the printer power is on or off, or while the printer is

printing.

1 If the printer has a lock, unlock the printer. Lift the output tray cover and set aside

(step 1 in Figure 5-7).

2 Hold the card output tray and pull back on the card pusher. Lock it in the notch on

the bottom of the output tray (step 2 in Figure 5-7).

Figure 5-7: Remove completed cards

3 Lift cards from the output tray (step 3 in Figure 5-7).

Cards toward the front of the printer were printed before cards toward the rear of

the printer.

ICIV003U