User`s guide

5-4 Using the printer
User’s Guide for the ImageCard® IV Printer
Powering on the printer and PC
Use the following procedure to power on the printer and attached PC. You might
change this procedure based on your policy.
Power on the printer and PC
If the printer is connected over a network using a print server, make sure the
driver is installed and configured on the PC before using it.
1 Load cards in the input tray. Make sure all supplies are loaded. See “Loading
supplies” on page 4-1 for more information.
2 Remove any printed or rejected cards from the output tray. See “Removing cards”
on page 5-15.
Status Light Description
Red Amber Green
The printer is starting.
Steady green
The printer is ready and waiting for cards.
Blinking green
The printer is busy printing cards.
Steady amber
The printer is paused without an error.
Blinking amber
The printer has issued a message. See the PC for the
message.
Steady red
The printer has a problem that requires service.
Off
The printer top cover is open, such as when replacing
supplies or fixing a problem.
If cards were processing when the cover was opened,
see “Interrupted printing” on page 5-11 to correct the
situation.
i