User`s guide

Loading supplies 4-11
User’s Guide for the ImageCard® IV Printer
Loading supply in the cartridge
After removing the supply cartridge from the printer, remove the used material and
load new material.
Load supply in the cartridge
1 Place the supply cartridge upside down on a level surface, such as a table, with
the wide side away from you.
2 Remove the spool caps (if used).
3 Pull up firmly on the full take-up spool to remove it.
4 Remove the end of the supply material from the empty supply spool if needed.
Dispose of the used supply according to your policy.
On a regular basis, such as weekly, use the cleaning pen to clean deposits
from the guides of the supply cartridge and clean the supply tracker.
5 Remove the empty spool from the holder and press it into place on the take-up
holder (step 1 in Figure 4-9). Make sure the ribs inside the spool align with the
grooves in the holder.
6 Press on the spool and turn it slightly (if needed) until the spool fully covers the
ribs of the holder.
7 Unwrap the new supply material.
8 Place the full supply roll on the right holder as you face the open side of the
cartridge (step 2 in Figure 4-9). Make sure the supply will unroll counterclockwise
, as shown.
Figure 4-9: Load supply in the cartridge
9 Make sure the ribs inside the spool align with the grooves in the holder. Press on
the spool and turn it slightly (if needed) until the spool fully covers the ribs.
E
Take-up spool
Supply roll
5
1
4
3
2
Spool caps
Guides