User`s guide

Loading supplies 4-5
User’s Guide for the ImageCard® IV Printer
Figure 4-4: Replace the print ribbon cartridge in the printer
3 Lower the print ribbon cartridge into the printer (step 1 in Figure 4-4). Make sure
the ribbon passes between the printhead cage and the print platen roller.
Make sure the print ribbon passes through the color sensor (marked “S” in
Figure 4-4).
4 Press down firmly to seat the print ribbon cartridge in the printer. Lower the
cartridge handle if needed.
5 Lift the printhead latch and press the printhead cage forward until it is upright (step
2 in Figure 4-4). Make sure the printhead latch clicks into place. Push down on the
printhead latch if needed.
6 If there is slack in the print ribbon, turn the ribbon take-up knob clockwise to
take up slack (step 3 in Figure 4-4).
7 Close the cover of the printer, and press to latch it in place. If the printer has a
lock, lock the printer.
♦
Changing the cleaning tape
This section describes the three steps of changing the cleaning tape:
• Remove the cleaning tape cartridge
• Load the cleaning tape in the cartridge
• Replace the cleaning tape cartridge
iciv170u
2
1
S
1
3
2
1
E