User`s guide

3-10 Setting up the printer
User’s Guide for the ImageCard® IV Printer
Figure 3-10: Set the card thickness
– If the card cannot move past the separator, turn the card separator knob
clockwise until the card can slide past the separator.
– Then, turn the card separator knob clockwise one-quarter turn to allow for
normal variations in thickness.
5 Check the setting using a few more cards of the desired thickness. Push a card
between the guide rollers, so the edge is past the card separator. Remove your
hand from the card to determine if the setting is correct.
Figure 3-11: Correct card thickness setting
iciv071u
.035 - .055 inch
(.89 - 1.4 mm)
.018 - .028 inch
(.46 - .71 mm)
Card separator knob
Card separator
Guide roller
iciv066u
Card separator
Card
Guide rollers