User`s guide

Setting up the printer 3-9

User’s Guide for the ImageCard® IV Printer

Set the card separator

1 Remove the cover of the input tray. If the tray has a latch, turn the latch one-

quarter turn counterclockwise to release the tray (Figure 3-9).

2 Lift the input tray and set aside (Figure 3-9).

Do not tip the tray upside down. The latching pin can fall out and the pin is

required for the tray to operate properly.

Figure 3-9: Remove the card input tray

3 Refer to the packaging for your card stock to determine the nominal thickness of

the cards you use. This procedure assumes that the printer is set for 0.030 inch

(0.76 mm), and explains how to adjust for cards that are thicker or thinner.

Use 2 or 3 cards for this setting.

4 Place a card of the desired thickness between the guide rollers (Figure 3-10).

Then, do the following:

– If the card slides past the separator and you can see extra space between the

card and the separator, turn the card separator knob counterclockwise

until the separator touches the card.

– Then turn the card separator knob clockwise one-quarter turn to allow for

normal variations in thickness.

ICIV064U