User`s guide

User’s Guide for the ImageCard® IV Printer
A Laminate material default
settings
This appendix describes the default settings to use for
different topcoat and laminate materials. Use these values:
• To compare with the settings currently used by the printer
• To setup the option station for a material that is not included in the Material
Settings list in the Printer Toolbox
Use the Advanced Setup Laminator -Advanced tab to view the values in the printer.
The default values are based on testing and should be used as starting points. You
might need to change these settings to compensate for differences in card stock,
supplies, and printers.
Topcoat
The following are default values for topcoat materials that can be used in a topcoat
station with a
rubber-coated heated roller:
The following are default values for topcoat materials that can be used in a topcoat
station with a
metal heated roller:
Laminate
The following are default values for laminate materials that can be used in an overlay
station with a rubber-coated roller:
Material Temp Speed Pressure
Holographic Topcoat 190 300 1550
Clear Topcoat 190 300 1550
Material Temp Speed Pressure
Holographic Topcoat 160 300 1550
Clear Topcoat 160 300 1550
Material Temp Speed Pressure
DuraGard™ 0.5 Mil
Clear Laminate
210 200 1550
DuraGard 0.6 Mil
Holographic Laminate
210 200 1550