User`s guide

Maintaining the printer 7-19
User’s Guide for the ImageCard® IV Printer
Figure 7-17: Pass the connector through the printhead cage
4 Lift the printhead cage to move it to the resting position.
5 Grasp the printhead and align the side pins with the clips in the printhead cage.
Press firmly on the ribbed side of the printhead (step 1 in Figure 7-18) and then
the flat side (step 2 in Figure 7-18) in until the pins are firmly seated in the clips.
Make sure both side pins are firmly seated in the clips.
Figure 7-18: Replace the printhead in the cage
If the printhead does not look similar to Figure 7-18 or does not snap into place,
the printhead cartridge might be backward.
iciv179u
3
1
2
i
iciv088u
1
2
Side pin
Side pin
Clip
i