User manual

Operation and IR Control
Source Side
Method A: Push Button
Push the switch button on the front panel, the source will be sequentially changed.
Method B: IR Remote Control
a. Please press F1 to F4 to enter IR control mode and decide which output port to be
controlled by pressing F1 to F4, and wait a few seconds for audio/video of next
channel coming out after the channel switch command is sent.
Note
If the setting is correct, the corresponding LED will flash. If not, please press
output port select button again.
F1 HDMI output #1
F2 HDMI output #2
F3 HDMI output #3
F4 HDMI output #4
b. Use or keys to select input source, and
wait a few seconds for audio/video of next channel
coming out after the channel switch command is
sent.
Note
If the setting is correct, the corresponding LED will
flash. If there is no response, please wait until the
LED stops flashing, and try again.
Left button to switch channels in ascending order (1, 2, 3, 4, 1, ...)
Right button to switch channels in descending order (1, 4, 3, 2, 1, …)
9 / 15