User manual

DIP Switch
SW1-SW4 for EDID/Audio
DIP Switch
Position
Pin#1 Pin#2
Video Audio Description
OFF [©] OFF [©] Up to 1080p Stereo
1
Default Mode
2
– Up to 1080p & stereo audio
output for most HDTVs
OFF [©] ON [ª]
Up to
720p / 1080i
Stereo
Safe Mode
3
– Enforce the system output at
720p/1080i video and stereo audio for basic
compatibility among HDTVs
ON [ª] OFF [©] Bypass
4
Bypass
4
EDID Learning Mode
5
– for learning EDID
from the display while playing any received
HDMI audio format
ON [ª] ON [ª] Bypass Stereo
EDID Learning & Stereo Mode
5
– for learning
EDID from the display while enforcing stereo
output if any HDTV cannot play surround
sound normally
Note
1
If the HDTV shows video but without audio, please try to set audio mode to
stereo.
2
Factory default of SW1-SW4: Pin#1-OFF [©] & Pin#2- OFF [©] for 1080p with
stereo.
3
If you encounter any unsolved audio/video output problem during system
installation, please turn any SW1-SW4 to Pin#1-OFF[©] & Pin#1-ON[ª], for safe
mode to enforce the most compatible 720p stereo output for system check.
However, the safe mode cannot be initiated if your HDMI source is set to
enforce 1080p output. In this case, please reconfigure your HDMI source to all
resolution output for troubleshooting.
4
Bypass means the matrix will maintain playing the original format of HDMI
signals in video and perhaps audio. By setting at this mode, the users may
encounter compatibility issue among different kinds of HDMI sources and
displays. If you cannot get the audio and/or video output normally at the
system installation, please change the DIP switch setting to default mode or
even safe mode to verify the functionality of the device.
5
Set Pin#1 at ON[ª] first then connect the HDMI Input to HDTV through a HDMI
cable. Wait for 20 seconds. The EDID learning procedure will be finished. If you
want to learn the EDID from another HDTV, you must set Pin#1 at OFF[©] first
and repeat this procedure.
6 / 15