Specifications

Shop online now at: www. .com
Interactive &
Projectors
Signage/3DAV Signal
Distribution
ConnectorsCamerasDVRs Brackets Racks &
Cabinets
352
Cables
Faceplates
• SONET4: Cat5 Audio Distribution System -
4 in / 4 out
The highly successful ‘Sonet’ Sound-over-Ethernet System has
been designed to simplify and speed up installations where multiple
microphone or line level inputs need to be situated a distance from
the amplifier equipment.
Types of installation include churches, schools, theatres and corporate
boardrooms.
This extremely versatile and cost effective installation device removes
the need for multiple cable runs from remote audio inputs to the
amplifier equipment. The SONET4 System can transmit up to four
microphone or line level signals down one screened Cat5e cable
for up to 1000m.
Each input and output can be independently configured for balanced
or unbalanced signals as well as line level or microphone level. There
is also an option to provide phantom power to the microphone inputs
independently.
Each unit fits neatly into a standard UK double-gang back box and
only requires a power supply at the output or amplifier end (PSU
supplied as part of system).
Features:
• Reduces installation time
• Up to 1000m between Input and Output plates achievable
• Very high interference immunity
• Balanced or unbalanced inputs & outputs
• Line or Microphone level inputs & outputs
• Phantom power (max. 15v DC)
• Four XLR sockets on standard 2 gang plates
• No power required at input module
• Power Supply included as part of system
Please Note:
• When using Cat5 UTP (unshielded) cable, the So.Net system is only
capable of transferring up to 3 channels. STP (shielded) Cat5 cable will
allow for the maximum 4 channels.
4 x MIC/LINE Signals
LINE Out
so.net OUTPUT plate
Standard single
Cat5 cable
(up to 1000m)
so.net INPUT plate
PSU
Specications:
Input Module:
Power Over Cat5 cable
Ground Over Cat5 cable screen (or spare pair)
Inputs x 4 Balanced XLR female
MIC/LINE in Selectable by jumper
Phantom Power 15v jumper selectable
MIC Impedance 600
W
MIC Level Input 10mv RMS
LINE Impedance 50k
W
LINE Input Level 700mv RMS (1.5v RMS max)
Cat5 Termination Screw terminals
Output Module:
Power Requirements 24v DC @ 100mA (regulated linear power supply recommended)
Outputs x 4 Balanced XLR male
MIC/LINE Out Selectable by jumper
MIC Out Impedance 600
W
MIC Level Output 20mv RMS (into 600
W)
LINE Out Impedance 20k
W
LINE Level Output 700mv RMS (into 20K)
General:
Channels Four, individually configurable
Bandwidth 100Hz ~ 20kHz (-3dB)
Crosstalk >60dB
Signal to Noise Ratio >60dB
Cable Spec Screened Cat5e cable (UTP can be used, but one pair required for
ground,meaning only three channels would be available)
Cable Length 1000m maximum
Cat5 Terminators Screw terminals
Protected against short circuit on Cat5 cable to ground
Amplifier / Mixer
Linked via
Cat5 cable
Up to 1000m