Specifications

Interactive &
Projectors
Signage/3DAV Signal
Distribution
CamerasDVRs BracketsConnectors
Racks &
Cabinets
349
[e-mail] [phone]
Cables
Faceplates
• Outreach Plates: Audio Input Extension System
A range of wall, ceiling and desk mountable single gang audio input plates specifically designed
to increase the audio input capability of any audio system. A total of six plates are available
- one to suit virtually every conceivable variant of audio input connector - and each featuring
a built-in mixer, pre-amp, input level control and balancing output.
Up to ten plates of any mix can be daisy-chained to one balanced line level input with cable
lengths in excess of 100m easily achievable using standard two-pair audio cable (i.e. Belden
8723) with no recognisable degradation of audio signal quality.
All plates are surface mountable on 25mm single-gang back boxes and can be installed at
the most convenient point on an installation, thus overcoming the need for long and potentially
hazardous microphone/audio leads.
• APJ: 3.5mm Jack Outreach Plate
Accepts balanced or unbalanced microphones with 3.5mm mono jack plugs. Includes an
onboard mic-to-line level converter, high gain pre-amplifier and 8v phantom power.
• APL: Dual Phono Line Level Outreach Plate
Accepts two line-level signals (usually from a stereo source such as a TV, CD, MP3 or DVD).
Includes an on-board dual phono to mono converter. An ALS SCART to dual phono lead is
also available to facilitate the connection of TVs, VCRs, etc, to the APL.
• APQ: ¼” Jack Outreach Plate
Accepts balanced or unbalanced microphones with 1/4” jack plugs. Includes an on-board
mic-to-line level converter, high gain pre-amplifier and 8v phantom power.
• APXM: XLR Microphone Level Outreach Plate
Accepts balanced or unbalanced microphones with standard 3 pin XLR female connectors.
Includes an on-board mic-to-line level converter, high gain pre-amplifier and 8v phantom
power.
• APXL: XLR Line Level Outreach Plate
Accepts standard 3 pin XLR female feeds from audio equipment such as stage or church
mixing desks, etc.
• APM: Omni-Directional Plated Mic Outreach Plate
A self-contained omni-directional electret microphone complete with on-board mic-to-line
level converter. Ideal for mounting in ceilings, walls or desks, the unit offers excellent coverage
(typically up to 25m
2
when located at a ceiling height of 2.5-3m).
• Ancillary Devices:
Should the Outreach network be connected to an induction loop system, any of the following
ancillary devices can be added:
• API: ‘AFILS Active’ Outreach Plate
Includes two ultra-bright LEDs in a translucent diffuser overprinted with the induction loop
‘ear’ symbol. The LEDs illuminate when the outreach network is powered to indicate that an
AFILS system is installed. Current consumption is 30mA max.
• APF: Field Strength Meter Outreach Plate
Indicates the magnetic field strength generated by an induction loop system via three LEDs,
labelled +6dB, 0dB and –6dB. The LEDs illuminate as appropriate whenever a signal is present
and can be easily set up to indicate the magnetic field strength in the room centre.