User manual

User Manual
14
15
Installation Diagram of System Receiver and Trans
(6) System Expansion through UTP: This series can stack into maximum
three layers of UTP section to reach more AV outputs and depends on
the display devices, you may reach a lower VGA solution than single
layer. The suggested range of VGA broadcasting is 800x600@900m,
1280x1024@600m, and 2048x1536@300m. Please be noted that you
must use Transceiver for intermediate expansion.
Stack Three Layers of AV Extender through Cat5e to Reach more Displays
One-Port Receiver
VGA output Devices
Projector PDP LCD CRT
VGA/Audio
Transmitter
Transceiver
Transceiver
Cat5e cable-Layer 1
Cat5e cable-Layer 2
Cat5e cable-Layer 3
(3) Local Function Test: Power on your AV device, the “ACTIVE” LEDs of
Transmitter will turn on orange to indicate the video activation, and you
should ready to do AV broadcasting.
Installation Diagram of System Transmitter
(4) Receiver Installation: Please follow previous section 2 for AVE-301R to
install the system Receiver, and the maximum extended length of this
section should not exceed 300 meters.
(5) Transceiver Installation: If you wish to have more AV displays, you can
use system Transceiver, you may use 4/8-Port Transceiver model to
expand one AV signal to 4/8 AV signals. In the other way, you may stack
more system Transmitter through their local AV port to generate more
AV RJ-45 outputs locally and the maximum local stacking capacity is
limited to 4 layers to ensure good broadcasting quality. Please follow
next two section for instruction.
VGA/Audio
4/8/16-Port Transmitter
One-Port Receiver
VGA output Devices
Projector PDP LCD CRT
Use Cat5e cable
Max : 300M
VGA/Audio
4/8/16-Port Transmitter
4/8-Port Transceiver
Receivers
4
～
8 Set Cat5e
4
/
8 RJ45
AV Outputs