Instruction manual

9
- Press the ENTER button to display the OSD Blending setting position.
- Press the UP or DOWN button to select the OSD blending value (from 0~7).
NB: OSD Blending value 0 = Min transparency 7 = Max transparency
- Press the ENTER button to save the OSD blending value.
- Press the UP or DOWN button to highlight the Time Code setting.
- Press the ENTER button to toggle the on screen Time Code display ON/OFF.
- Press the UP or DOWN button to highlight the TC Position setting.
NB: TC Position is used to set where on the monitor Time Code will be shown.
- Press the ENTER button to cycle through the possible Time Code Positions on the monitor
(Left/Up, Middle/Down, Right/Down, Right/Up)
- Press the UP or DOWN button to highlight the TC HD Line setting.
- Press ENTER button to cycle through the possible HD time code lines (8~20).
- Press the UP or DOWN button to highlight the TC SD Line setting.
- Press ENTER button to cycle through the possible SD time code lines (10~21).
- Press the UP or DOWN button to highlight the TC Font Size setting.
- Press ENTER button to cycle through the possible time code font sizes on the screen
(Large or Small).
- Keep pressing the MENU button to cycle through the main menu options.
- Press the SOURCE button to exit the menu mode.
5. Advance
- Press the MENU button five times to display the Advance setting menu.
- Press the ENTER button to highlight the LCD L/R Scan setting.
NB: The LCD L/R Scan will reverse the image displayed horizontally.
- Press the ENTER button, the screen image will be reversed (Left to Right).
- Press the ENTER button again, the screen image will return to normal view.
- Press UP / DOWN button to highlight the LCD U/D Scan setting.
NB: The LCD U/D Scan will reverse the image displayed vertically.
- Press the ENTER button, the screen image will be reversed (Top to Bottom).
- Press the ENTER button again, the screen image will return to normal view.
- Press UP / DOWN button to highlight the Reset option.
NB: This option will return the monitor to the factory default settings.
- Press the ENTER button to re-start the monitor with the factory default settings.
- Press UP / DOWN button to highlight the Version setting.
- Press the ENTER button, the firmware version will be displayed on screen.
- Keep pressing the MENU button to cycle through the main menu options.
- Press the SOURCE button to exit the menu mode.