User manual

Installation and Setup
2-28 ProMaster 2500 User Manual
Print Shift
Change this value using the STOP command described in the following
procedure.
1. Press
STOP
to pause the 2500 while a Task is running.
2. Press
LOWER CASE
+
P
. The display on the 2500 prompts you to
enter a new value.
3. Press
↑
and
↓
to enter a new print shift value between 0 and 16.
Entering a larger numeric value moves the printed character higher
on the label.
4. Press
START
to continue running the Task.
Label Calibration
Change the label calibration value using the STOP command described in
the following procedure:
1. Press
STOP
to pause the 2500 while a Task is running.
2. Press
LOWER CASE
+
C
. The 2500 displays:
where
XXX
represents a numeric value for the current setting.
3. Press
↑
and
↓
to change the label calibration value (the range is from
0 to 255). Entering a larger numeric value moves the printed
characters closer to the leading edge of the label.
4. Press
START
to continue running the Task.
Label Advance
The label advance value defines how far a label extends above the
application plate before it is applied to a device.
The value can be changed by pressing
STOP
and
LOWER CASE
+
W
.
Increasing the numeric value advances the label farther above the
application plate.
Figure 2-19
Label Calibration
(affects horizontal position)
PROGRAM/TEST LABEL
SLAVE MODE PART TYPE: DIP 24-.3
PART TOTAL: 251 PART LENGTH: 1.250
LABEL CAL: (XXX)
2177-1
NORMAL
HIGHER VALUE