User manual

Installation and Setup
2-26 ProMaster 2500 User Manual
Label Adjust
This is a fine-tune adjustment of the label placement value when it is set
to “autocenter.”
To change the value when the 2500 is in the local mode, press
3
from the
LABELER SETUP MENU.
The 2500 displays:
Use the 2500’s keyboard to change the displayed value. Increasing the
number moves the label farther from the leading edge of the device.
When you have entered the desired value, save it by pressing
ENTER
.
The 2500 records this value and returns to the LABELER SETUP MENU.
To change this setting while the 2500 is running a Task, press
STOP
and
then
LOWER CASE
+
A
. The 2500 displays:
Enter the new value on the 2500’s keyboard, and then press
ENTER
to
save the value. Press
START
to continue the Task and check the next
device.
Dot Split Value
This setting is adjusted at the factory and should not need to be changed
unless you need to adjust print quality. If the vertical strokes on your
label characters are fuzzy you may need to adjust the dot split value. Any
change in this value affects all the character fonts.
To check or adjust the split value, follow the steps below.
1. Create a label file using the letter E in the 20 font.
2. Select the PRINT ONLY command in the local mode (see page 2-22).
3. Press
LOWER CASE
+
S
while in Print Only mode.
* * * LABELER SETUP MENU * * *
1 - LABEL CALIBRATION 4 - SETUP MENU
2 - LABEL PLACEMENT
3 - LABEL ADJUST
ENTER LABEL ADJUST VALUE (X): _
PROGRAM/TEST LABEL
ENTER LABEL ADJUST VALUE (X): _
Figure 2-17
Changing the Dot Split Value
PRINT LABEL
ENTER DOT SPLIT VALUE (XX): _
1938-2
NORMALBLURRED TEXT