User manual

Installation and Setup
ProMaster 2500 User Manual 2-21
General 2500 Setup
The following procedures describe changing the system’s serial port baud
rates and enabling or disabling the audible alarm. You must put the 2500
in local mode before performing these steps. Other 2500 front panel
commands are described in Chapter 6 and Appendix F.
Remote and Programmer
Port Baud Rates
The default baud rate of the remote and programmer ports is 9600. To
change either baud rate follow the procedure below.
1. From the 2500 Main Menu, press
3
to select SYSTEM SETUP.
The 2500 displays:
2. Press
1
to select the GENERAL SETUP MENU.
3. Press
2
to select REMOTE BAUD RATE.
4. Press the number corresponding to the baud rate you want to use. To
return to the Main Menu, press
RESET
.
Audible Alarm
If the AUDIBLE ALARM is enabled, a tone is emitted for every keystroke
and error message. To enable or disable the Audible Alarm, press 1 from
the General Setup Menu. If the alarm is currently enabled, the 2500
displays:
If it is disabled, ON appears instead of OFF. Press
Y
if you want to toggle
to the other state.
* * PROMASTER 2500 MAIN MENU * *
ENTER THE NUMBER OF THE DESIRED FUNCTION
1 - OPERATIONS 3 - SYSTEM SETUP
2 - FILE UTILITIES 4 - DIAGNOSTIC
* * * SYSTEM SETUP MENU * * *
1 - GENERAL 4 - MAIN MENU
2 - LABELER
3 - HANDLER
* * * GENERAL SETUP MENU * * *
1 - AUDIBLE ALARM 4 - SETUP MENU
2 - REMOTE BAUD RATE
3 - PROGRAMMER BAUD RATE
ENTER NUMBER OF REMOTE BAUD RATE
DESIRED (X):
1 - 1200 2 - 2400 3 - 4800 4 - 9600
5 - 19200 6 - 38400
DO YOU WANT AUDIBLE ALARM OFF?
(Y OR N):