User manual

Installation and Setup
2-18 ProMaster 2500 User Manual
Starting TaskLink
TaskLink operates in two different modes: Administrator and Operator.
Administrator mode allows access to all parameters so that Tasks can be
created. Operator mode (the default) is used during a production run
when streamlined operation and high throughput are most important.
From the DOS prompt, start TaskLink in Administrator mode by entering
tl a
on the PC. (Enter
tl
to start TaskLink in Operator mode.) The main
TaskLink screen is displayed.
Note: TaskLink can also be operated when the PC is not connected to the 2500.
To run this simulation mode, enter
tl as
at the DOS prompt.
Exiting TaskLink
In Administrator mode, exit TaskLink from the main screen by pressing
A
LT
+
X
.
Turning on the 2500
To start the system, make sure you are in Administrator mode and at the
TaskLink main screen and follow this brief procedure:
1. Confirm that the air input line has been installed and the high and
low pressure gauges indicate that air is reaching the 2500.
CAUTION: The noise level generated by an operating 2500 can exceed 70
dB. Long term exposure to this level of noise could cause
hearing loss. Personnel working near the 2500 should wear
hearing protection.
2. Turn on the 2500. The 2500 powers up and communicates with
TaskLink when the system self-test is completed.
Figure 2-13
TaskLink Main Screen
(Administrator Mode)