User manual

Installation and Setup
2-12 ProMaster 2500 User Manual
Installing the Dot Matrix
Printer Ribbon Cassette
Install the labeler ribbon cassette in the dot matrix printer by following
this procedure (see Figure 2-10):
1. Rotate the knob on the new cassette in the direction indicated by the
arrow (counter-clockwise) to pull the ribbon taut.
2. Guide the new cassette so the ribbon fits between the print head and
the platen.
3. With the ribbon now partially in place over the print head, slowly
turn the cassette knob while applying gentle pressure on the cassette
until it drops into place on the ribbon spline drive. The spline drive is
located on the labeler directly behind the ribbon advance knob.
Note: You will have to turn the ribbon advance knob slightly until the slot on
the back of the cassette aligns with the spline drive.
4. Ensure that the ribbon is in place by lightly pulling on it. It should not
come off the clips.
5. Calibrate the labels (see page 2-10).
Figure 2-10
Installing the Labeler Ribbon
Cassette in the Dot Matrix Printer
1852-2
PRINT HEAD
SPRING CLIP
(1 of 2)
RIBBON
ADVANCE
KNOB
RIBBON
CASSETTE