User manual

ii Technical Review UniSite User Manual
Figure 3-18. Commands Available from the Options Pull-down Menu..3-
28
Figure 3-19. Selecting Security Options.....................................................3-29
Figure 3-20. Password Screen for System Operators...............................3-30
Figure 3-21. Configuring Operating Preferences.....................................3-31
Figure 3-22. Selecting “Add Kit” from the Main Screen.........................3-32
Figure 3-23. Kits are a Series of Tasks in a Single Job..............................3-33
Figure 3-24. Edit Kit Screen.........................................................................3-34
Figure 3-25. Naming the First Task in the Kit..........................................3-34
Figure 3-26. Adding the Second Task to the Kit ......................................3-35
Figure 3-27. Sample Message Presented to System Operator when Kit Is Run
3-36
Figure 3-28. Selecting the Batch File Command.......................................3-38
Figure 4-1. Overview of the Procedure for Starting a Task......................4-3
Figure 4-2. TaskLink Operator Screen.........................................................4-5
Figure 4-3. Enter Your Name on the Security Screen................................4-6
Figure 4-4. TaskLink Main Operator Screen...............................................4-6
Figure 4-5. Configuring Blocks on a Programming Module....................4-8
Figure 4-6. Configuration Box Compartments...........................................4-9
Figure 4-7. Configuration Box Lid—Optional Configurations for 28-pin Module.
4-10
Figure 4-8. Installing a Programming Module.........................................4-12
Figure 4-9. Adjusting the Track Width — Turning the knob clockwise
opens all three track sections together. .....................................................4-13
Figure 4-10. Final Track Adjustment.........................................................4-14
Figure 4-11. Closeup View of Input Track with 8-pin 150-mil Device
Keeper Bar Assembly Installed ..................................................................4-15
Figure 4-12. 8-pin 150-mil SOIC Device Keeper Bar Assembly Mounted in
the Input Track..............................................................................................4-16
Figure 4-13. Chuck Selection Chart............................................................4-16
Figure 4-14. Adjusting High and Low Air Pressure................................4-17
Figure 4-15. Threading New Labels in the Dot Matrix Printer..............4-19
Figure 4-16. Threading Labels in the Thermal Printer............................4-21
Figure 4-17. Installing Devices in the Tube Holder................................. 4-23
Figure 4-18. Main Operator Screen in TaskLink......................................4-23
Figure 4-19. Choosing a Process From Those Presented on the Screen 4-24
Figure 4-20. Checking the Sumcheck.........................................................4-25
Figure 4-21. Setting Pass Limit and Parts Per Tube.................................4-25
Figure 4-22. Aligning Beam to the Device ................................................4-27
Figure 4-23. Aligning Device to the Module ............................................4-28
Figure 4-24. Checking the Front-to-Back Alignment (looking from the
perspective of the input track)....................................................................4-29
Figure 4-25. Device too Close to the Front................................................4-30
Figure 4-26. Device too Close to the Back.................................................4-30
Figure 4-27. DIP Device Alignment...........................................................4-32
Figure 4-28. TaskLink Status Screen During Device Processing...........4-33
Figure 4-29. Task Session Summary Screen..............................................4-34
Figure 4-30. Kits are a Series of Tasks in a Single Job..............................4-35
Figure 4-31. Overview: Running a Kit (the number by each screen refers to
the number of the step describing it on the previous page.................... 4-37
Figure 4-32. Track Air Adjustment Knob..................................................4-38
Figure 5-1. Optic and Microswitch Locations ............................................5-3
Figure 5-2. High and Low Pressure Air Lines..........................................5-10