User manual

ProMaster 2500 User Manual 2-1

Installation and Setup

For Administrators

This chapter describes how to install and start the ProMaster 2500 and is

directed to system administrators. You should be familiar with the

information described in Chapter 1 before performing the operations

described in this chapter. System operators should skip Chapters 2 and 3

and read the daily operating procedures described in Chapter 4.

The procedures in this chapter include connecting the RS-232C cables,

connecting the external air line, installing and starting TaskLink,

installing the periodic system disk updates, and confirming that the

system is communicating and that no errors were detected during the

powerup self-test.

The information in this chapter is organized as follows:

Before You Install ....................................................................................2-2

Unpacking and Inspecting the 2500......................................................2-2

Installing the 2500....................................................................................2-4

Connecting the PC and Installing TaskLink......................................2-16

Turning on the 2500...............................................................................2-18

Adjusting Print Quality and Position.................................................2-22

Updating the 2500..................................................................................2-29