User manual

Index
Index-8 ProMaster 2500 User Manual
T
Task
adding, 3-4
defined, 3-2
Logic Task parameters, 3-4
Memory Task parameters, 3-14
naming, 3-5
saving, 3-12
selecting a data source, 3-7
selecting a device, 3-6
selecting data file, 3-7
selecting package type, 3-9
selecting the process, 3-8
translation format, 3-7
Task parameters
data sumcheck, 3-18
memory devices, 3-14
TaskLink
adding a task, 3-4
communication with 2500, 2-19
database file defined, 3-5
error messages, 6-1—6-5
exiting, 2-18
general description, 1-2, 1-12
installing, 2-17
load from master device, 4-26
modes of operation, 1-12
modes, defined, 2-18
naming a Task, 3-5
operating modes, 2-18
saving a Task, 3-12
self-test, 5-53
setup, 2-16
starting, 2-18
theory of operation, 5-2
TaskLink screens, 1-13—1-15
Technical assistance, xix
Technical support, 1-19
Temporary file, editing, 5-43, F-3
Terminal/Host command, 3-7
Test vectors
DIP/PLCC translation, 3-14
on PLD devices, 3-13
See Also Functional test
serial vector test, 3-14
Theory of operation
calibration of labels, 5-15, 5-17
controller board, 5-13
device processing, 5-2
dot matrix printer, 5-15
label calibration, 5-7
microswitches, 5-7
optics, 5-7
programming, 5-4, 5-20
solenoids, 5-8
stepper motor, 5-8
TaskLink, 5-2, 5-4
the beam and chucks, 5-8
thermal printer, 5-17
Thermal printer
adjusting, 5-27
adjusting label print position, 5-26
adjusting print intensity, 2-29
fonts, 5-17
installing ribbon, 2-15
repairing a torn ribbon, 5-60
repairing torn ribbon, 2-16
replacing ribbon, 5-59
setting up, 2-13
theory of operation, 5-17
Time-out delay, programming module, B-2
Tools for preventive maintenance, 5-55, 5-60
Toroid PCB, replacing, 7-19
Toroid transformer, replacing, 7-19
Track
adjustment, 5-64
cleaning, 5-56
optics, 5-7
Track air, adjusting, 4-38
Track width, adjusting, 4-12
Translation format, selecting, 3-7
Traverse stepper motor, 5-8
Troubleshooting
flow charts, 6-6
optics, 5-7
overview, 6-1
Tube 1, 3-28
Typographic conventions, xxii