User manual

Index
ProMaster 2500 User Manual Index-7
Repairing torn ribbon (thermal printer), 2-16, 5-60
Replacing
anti-backlash nut, 7-24
beam gasket, 7-25
beam head rotation motor, 7-14
chuck tip, 4-17
controller board, 7-20
controller power supply, 7-19
DIP module contacts, 7-28
disk drive, 7-27
dot matrix printer ribbon cassette, 5-57
flex coupler, 7-21
input orbital motor, 7-7
input orbital tube clamp, 7-15
keyboard/display assembly, 7-28
labeler power supply, 7-20
lead screw, 7-23
left lead screw bearing assembly, 7-23
main fuse, 7-2
output orbital motor, 7-10
output orbital tube clamp, 7-16
pin insulation block, 7-34
PLCC module contacts, 7-30
PLCC module programming block, 7-36
print drive motor, 7-11
print head, dot matrix, 7-12
Programming Electronics assembly, 7-3
Programming Electronics power supply, 7-19
programming module clamp air cylinder, 7-17
right lead screw bearing assembly, 7-22
SOIC programming module pins, 7-33
solenoid, 7-18
system fan, 7-20
thermal print head, 7-13
thermal printer ribbon, 5-59
toroid PCB, 7-19
toroid transformer, 7-19
Requirements, input air, 2-2
Reset key, 1-10
Restore defaults, programming parameters, 3-26
Retries, programming, 3-28
RFI/EMI compliance, 1-18
Ribbon
installing, thermal printer, 2-15
repairing torn, thermal printer, 2-16, 5-60
replacing, thermal printer, 5-59
Ribbon cassette
installing, dot matrix printer, 2-12
replacing, 5-57
Ribbon not detected message, 6-4
Right lead screw bearing assembly, replacing, 7-22
RS-232C tests, 5-49
S
Safety
CE conformity, 1-18
operating noise level, 4-4
Screen movement, TaskLink, 1-13
Security fuse
check, 5-5
vectors used to verify, 3-13
Security fuse violation message, 6-4
Self-calibration, PE, 5-20
Self-test, Programming Electronics, 5-50
Serial number, programming, 3-21
Serialization
about, 3-21
External Serialization Program (ESP), 3-24
Service
contracts, 1-19
phone number, 1-19
procedures, preventive maintenance, 5-60
spares kit, 1-19
training, 1-19
Setting up labeler, 2-23
Shipped components, 2-2
SmartPort, 5-19
SOIC programming module pins, replacing, 7-33
Solenoid test, 5-37
Solenoids
replacing, 7-18
theory of operation, 5-8
Source code, Label C Program, E-16
SPA block, 5-20
SPA pins, cleaning, 5-56
Spares kit, 1-19
Specifications, 1-16—1-17
Squirt pin assembly block, 5-20
Standard programming electronics CRC, E-19
Starting TaskLink, 2-18
Statistics, logging, 3-19
Stepper motor, theory of operation, 5-8
STOP commands, 2-20, B-4—B-5
Sumcheck error message, 6-4
Support
see Customer Support
Switches, theory of operation, 5-7
System
fan, replacing, 7-20
memory, 1-16
parameters, B-3
requirements, PC, 1-12
self-check, 5-56
System Setup menu, F-9