User manual

Index
Index-4 ProMaster 2500 User Manual
G
General help index, 1-14
General setup, 2-21
General Setup menu, F-9
H
Halting an operation in CRC, E-17
Handler sorting, 3-28
Hardware did not pass self-test message, 6-3
Hardware handshaking, D-3, D-4
Help, online, 1-14
Hex Label Format
about, E-11
example, E-14
Hex label record, creating, E-14
Hood
interlock key, 5-31
operating position, 1-3
raising, 4-4
Host command, 3-7
I
ID error, 5-5
Illegal bit
description, 3-8
message, 5-5, 6-3
Index, general help, 1-14
Input air
about, 4-17
pressure, 4-17
requirements, 2-2
Input orbital motor, replacing, 7-7
Input orbital tube clamp, replacing, 7-15
Installation requirements, 2-2
Installing
chucks, 2-8, 4-16
input devices, 4-22
labels, dot matrix printer, 2-9
labels, thermal printer, 2-13
new 2500 firmware, 2-30
programming module, 4-12
ribbon cassette, dot matrix printer, 2-12
ribbon, thermal printer, 2-15
TaskLink, 2-17
Interlock key, hood, 5-31
J
Jams, device, 5-21
K
Kapton labels, ADC value, 4-18
Keep Current
algorithm, selecting, 3-6
subscription service, 1-19
Kernel circuit, 5-50
Keyboard, 1-11
Keyboard/Display assembly replacement, 7-28
Keyboard/display test, 5-48
Keystroke summary, TaskLink, 1-13
L
Label advance command (thermal printer), 2-28
Label C Program source code, E-16
Label calibration
adjusting, 2-24
command (thermal printer), 2-28
theory of operation, 5-7, 5-15
theory of operation, thermal printer, 5-17
Label detection optic calibration, 4-19
Label jam, press start message, 6-3
Label Only, F-2
Label operation in a Task, 3-9
Label placement
adjusting, 5-25
front panel commands, F-10
overview, 2-25
Label print position
adjusting, 5-25
adjusting, thermal printer, 5-26
Label record
content, E-11
types, E-11
Label supply reel
dot matrix printer, 5-15
thermal printer, 5-17
Label text, entering, 3-11
Labeler
checking application plates, 2-9, 5-26
general description, 1-6
power supply, replacing, 7-20
Labeler Hex format, E-11
Labeling
failing devices, F-12
serial numbers, 3-21