User manual

Computer Remote Control
ProMaster 2500 User Manual E-23
27 End of user RAM exceeded
28 Fatal device-specific programming error
29 Non-fatal device-specific programming error
2A Device Insertion error
Note: The two following errors have the same error code. For either error to
appear, you must have previously selected command
n23]
- where n = 0, 1,
or 2. If a 0 is chosen, there will be no error condition. (Select Verify
Option). If
1
was specified as the variable, use the first description. If
2
was specified, use the second description.
2B Structured test error (Vcc Nominal)
2B Structured test error (Vcc low)
2C Structured test error (Vcc high)
2D Base/Adapter for device not installed
2E Programming hardware hasn’t passed self-test
30 Device algorithm not found
31 Device over-current fault
3B No device present
40 I/O initialization error
41 Serial-framing error
42 Serial-overrun error
43 Serial framing/overrun error
46 I/O timeout
52 Data verify error
75 Security Fuse Violation
77 Security fuse programming error
79 Preload not supported by this device
81 Serial-parity error
82 Sumcheck error
84 I/O format error
88 Invalid number of parameters
89 Illegal parameter or invalid operation selected
8B Error restoring/saving CRC user-defined parameters or restoring
CRC entry defaults.
8E File error
8F NON-JEDEC data present in RAM or disk file, or else a non-logic
device was selected with a JEDEC I/O translation format selected
90 Illegal I/O format
94 Data record error
97 Block move error
98 End of device exceeded
99 End of file exceeded
9A Algorithm disk cannot be found